--- Go to the Woodblock.com Front Page ---

View unanswered posts | View active topics It is currently Fri May 25, 2018 10:04 pm



Post new topic Reply to topic  [ 2 posts ] 
Mold problems ... 
Author Message
User avatar

Joined: Wed Sep 02, 2009 2:05 pm
Posts: 33
Post Mold problems ...
Thanks for all your teachings!

I am doing a print where I am experimenting using several types of paper. Several sheets began to mold. I threw them out but am afraid of what may have happened. Are the other prints and my chipboard contaminated with spores?

My first go around my paper was wet for 7 days. The second go around is when the mold showed up at 4 days of the paper being wet under plastic.

The print is a two block reduction print. I have several more rounds to go.

Any advice? Thank you.


Mon Jan 03, 2011 3:58 am
Profile E-mail
Site Admin
User avatar

Joined: Mon Aug 31, 2009 2:30 pm
Posts: 194
Location: Tokyo, Japan
Post Re: Mold problems ...
As for the 'contamination' question, you have to realize that the mold (and the spores) are everywhere anyway. We live with that stuff surrounding us. It's in all our paper all the time.

Where it gets to be a problem is when you keep the paper in a 'fertile' condition for letting the stuff grow and develop, which you have obviously done. You say that 'some' sheets have begun to mold, but what you mean is that in those sheets, it has got far enough that you can see it. Believe me, it is very much present in the entire package, and the rest of the sheets will also be host to flourishing colonies, presumably just below the level of what you are able to see.

So yes, if these prints are something you consider to be important - that you wish to last a long time - then you have a big problem. If this were me, I would junk them and start again, but because you are doing reduction, that's not so easy. All I can recommend is that you dry them off, prepare a weak bleach solution, give them a thorough bath, dry them off, and then re-moisten and pick up where you left off.

Also, if you have visible mold showing up after four days, then either your workroom is way too warm (sun coming in through a nearby window?), or the paper was full of mold before you even got going ...


Mon Jan 03, 2011 4:06 am
Profile E-mail WWW
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Forum style by Vjacheslav Trushkin for Free Forums/DivisionCore.